Overhaul of PET bottle blowers

PET balloon devices may need to be overhauled and optimized after a period of use so that the performance of the devices will not be compromised over time.

In this article, we are going to introduce and review some of the major problems that have occurred so that by knowing them, you can take action to solve the problems that have occurred for your device.

If you are not able to solve the problem for your device, you can contact us to solve the problems for your device in the shortest time.

Repairs, troubleshooting and fixing

Many defects occur due to low maintenance, good repair has an important role in increasing the life of the device.

Tips on reducing major repairs

1. Dry the taps.

۲. Make sure the oil capacity is never less than 20 units.

3. Always keep equipment clean. Doing so will prevent damage to the device’s electrical components.

4. Check products regularly.

Why does the mold clamp not work?

This problem is possible for two reasons:

1. The power of the solenoid valve in the circuit is cut off. To solve this problem, you should check the circuit and the start of the switch, or increase the air pressure of the cylinder up to 8 to 10 times.
۲. The air in the cylinder seal leak and replace it with a new ring to fix the problem.
Note: The air pressure of the tanker should never exceed the stated value.

Stretching is not done? Or is the traction very slow?

This problem is possible for one reason: the air pressure is not enough. To solve this problem, you should check the cylinder sealing ring.

Why is there no wind removal?

This problem is possible for one reason: the air pipe or fittings are loose. To solve this problem, you must adjust or change the pipes.

Bottle blower motor and drive repairs

Pneumatic repair of bottle blower machine

Bottle blower machine plc repairs

Advice on testing and setting up a variety of PET bottle blowers

Specialized repairs of automatic and semi-automatic bottle and blower production machines